Every project starts from sketches. I do lots of skeches before starting modeling - it helps to visualize not only model itself, but also problems which might arise during modeling or animation process. ... mehr

These are In-Depth timelapse videos of my process of modeling a realistic male figure. I used box modeling technique for this particular piece. Started with a cube, roughing out the whole body, then separating ... mehr

In this tutorial I go through a technique for modeling a simple braid. Some tools used are EP Curve, extruding along a path, converting from NURBS to polygons and more…

This tutorial focuses on modelling an arch without using the boolean operation. This tutorial will show the method I used for making my arches in a building. There is obviously more than one way to do ... mehr

Before you begin the tutorial you should know that the tutorial will only work perfectly if you model the same car. This will save you a lot of frustration as you progress through each section. In order ... mehr

During this part of the car tutorial we will focus on the front bumper and adding all the details. To do this we will go over 5 tools: Offset Surface, Loft, Trim, Untrimmed, Round Tool, and Circular ... mehr

During this part of the car tutorial we will focus on the front bumper and adding all the details. To do this we will go over 5 tools: Offset Surface, Loft, Trim, Untrimmed, Round Tool, and Circular ... mehr

In this part of the tutorial we are going to be working on the back bumper. At this point we should know how to use most of the tools and the concept of working with trim and fillet surfaces. Feel free ... mehr

In this part of the tutorial we are going to be working on the Rims of the car. By using these techniques, anyone should be able to make any type of rim. I chose this ring because of the clean cut, but ... mehr

Welcome to my character walk through I’m not sure if you can call this a tutorial as I will just be showing different stages in the building of a character called Kreacher